Hikvision DS-2CD2042WD-I & 2CD20xx Series Bullet Camera Mounting Bracket - DS-1280ZJ-XS Aluminum Junction Back Box (4 Pack) for Outdoor Security Camera Installation

This is a high-quality product. The Reolink camera RLC-410 mounts perfectly. All of the wires fit inside the box. The only consideration here is that if you want a watertight seal through the side and want to use a patch cable that is terminated with a booted connector (like the one supplied with camera), you MAY need a little modification. The Reolink supplied cable has a wide boot that won’t slide through the supplied gland, or water-tight fitting. I actually used different, shorter cables as my runs were way less than 50 ft. The patch cables I used had a narrower boot that fit perfectly. You could probably shave down the boot on the supplied cable and the cap on the supplied gland and make it all work, and get a water tight seal when you tighten the nut. Using unterminated cable and crimping on your own connector presents another issue. Without a boot you will need to beef up the cable where it goes through the gland as the minimum diameter cable it will seal is 10mm cable and bare Ethernet cable is only about 5 mm. You can add electrical tape or heat wrap to that small area of the cable that goes through the fitting to get a watertight seal when you tighten the gland fitting.Other than the Reolink supplied cable being slightly too large to fit through the waterproof fitting, which a bit of modification can overcome if you chose to use it, this box meets all your needs for a great install. If you are up to the task of installing your cameras, it is not a big deal.The box looks like it comes with the Reolink cam. It’s just right and heavy duty. Even has a cable to hang the lid (and attached cam) for when you’re working inside a mounted box.